Showing
41 - 60
of 120
, query time: 0.01s
41) Chemical storage
Format:
Image
Lime, soda ash and copper sulfate (used in the zinc ore processing) stored beneath the mill at Gilman. Tracks used by timber trucks and ore cars run down the center of the picture. [Same as 2007.008.123]
42) Ore conveyor
Format:
Image
A mine ore conveyor being loaded from another level down a chute that had chains for filtering out large rocks. A miner stood near the conveyor and picked out pieces of wood and other debris.
Format:
Image
Steam control valves at the mill in Belden. These were located between the dryer and the loading tippel.
44) Steam controls
Format:
Image
Steam room controls located between the dryer building and loading tippel at Belden.
45) Mucking machine
Format:
Image
Air operated mucking machine preparing to load material. The scoop would go over the mucking machine and empty the ore into the cart behind. Operator controls were at the left side of the machine.
Format:
Image
Closeup of the flume used to dump "muck' onto the conveyor. This conveyor carried the ore to a series of crushing machines. Conveyors were used extensively in the mine. [related to photo 2007.008.090]
47) Tamping dynamite
Format:
Image
Miner's helper assisting with tamping dynamite prior to blasting the exposed rock face. Both miners have the battery powered safety lights connected by the long cord to a pouch on their waists.
Format:
Image
Lead flotation cell separating the lead from the crushed rock. Lead and gold were removed from the muck before the zinc was separated.
Format:
Image
Gilman power plant under renovation. The house in the immediate left background is where the Enzenroth family lived. Directly behind and to the left of the Enzenroth house is the Hess house. The Schlegel house is to the right of the Hess house. The school fence is visible at upper right.
Format:
Image
Power station upgrade in Gilman. The long house in the background is where the Schlegel family lived. The school yard fence is visible at upper right.
Format:
Image
Installing transformers and connecting terminals to main power line.
53) Bill Williams
Format:
Image
Bill Williams, geologist, cutting paper in the Gilman Mine office. A "table top" calculator is in the background.
Format:
Image
Carl Garner reconstructing a mine hoist used for moving ore and supplies in the mine.
Format:
Image
Tom Reed repairing a foot valve for one of the pumps which pumped water from the mine. The ever present miner's lunch bucket is in the background on the floor. Most miners used the same lunch bucket for many years until it became too dented to close. It was often hammered back or bent back into shape.
Format:
Image
O.A. McClain and Jesse Belt shearing bar steel for timber truck reinforcement. The shearing machine saved many tedious hours of sawing and cutting bar steel.
Format:
Image
Ed Koch starting the repair and reconditioning of a rocker dump mine car. This mine car has become unserviceable since the bottom and end are worn through. The car will receive new steel section plates and be completely reconditioned.
58) Machine Shop
Format:
Image
Bob Enzenroth in the machine shop at the Gilman Mine repairing and overhauling a jackhammer.
59) Shaft house
Format:
Image
An unknown miner oils the main cage mechanism in the shaft house. A grease gun can be seen on the floor in the right center of the picture.
Format:
Image
Frank Jones using a lathe for cutting centers on a shaft used by the Milling Department. "Jonesey" was known for his sense of humor and always seemed ready to share a joke.